Portal Apply Mac-Trigger-Server - HP FlexNetwork MSR Series Command Reference Manual

portal ipv4-max-user max-number
undo portal ipv4-max-user
Default
The maximum number of portal users allowed on an interface or a service template is not limited.
Views
Interface view
Service template view
Predefined user roles
network-admin
Parameters
max-number: Specifies the maximum number of portal users allowed on an interface or a service
template, in the range of 1 to 4294967295.
Usage guidelines
If the specified maximum number is smaller than the number of current online portal users on the
interface or service template, the limit can be set successfully. The limit does not impact the online
portal users. However, the device does not allow new portal users to log in from the interface or
service template until the number drops down below the limit.
Make sure the maximum combined number of IPv4 and IPv6 portal users specified on all interfaces
or service templates does not exceed the system-allowed maximum number. Otherwise, the
exceeding portal users will not be able to log in to the device.
Examples
# Set the maximum number of IPv4 portal users to 100 on GigabitEthernet 1/0/1. (Wired application).
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] portal ipv4-max-user 100
# Set the maximum number of IPv4 portal users to 100 on service template service1. (Wireless
application.)
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname–Vlan-interface100] portal ipv4-max-user 100
Related commands
display portal user
portal max-user

portal apply mac-trigger-server

Use portal apply mac-trigger-server to specify a MAC binding server.
Use undo portal apply mac-trigger-server to restore the default.
Syntax
portal apply mac-trigger-server server-name
undo portal apply mac-trigger-server
Default
No MAC binding server is specified.
267