Timer Response-Timeout (Radius Scheme View) - HP FlexNetwork MSR Series Command Reference Manual

Related commands
retry realtime-accounting

timer response-timeout (RADIUS scheme view)

Use timer response-timeout to set the RADIUS server response timeout timer.
Use undo timer response-timeout to restore the default.
Syntax
timer response-timeout seconds
undo timer response-timeout
Default
The RADIUS server response timeout period is 3 seconds.
Views
RADIUS scheme view
Predefined user roles
network-admin
Parameters
seconds: Specifies the RADIUS server response timeout period, in the range of 1 to 10 seconds.
Usage guidelines
If a NAS receives no response from the RADIUS server in a period of time after sending a RADIUS
request, it resends the request so that the user has more opportunity to obtain the RADIUS service.
The NAS uses the RADIUS server response timeout timer to control the transmission interval.
If the client times out during the authentication process, the user is immediately logged off. To avoid
user logoffs, the value multiplied by the following items cannot be larger than the client timeout
period defined by the access module:
•
The maximum number of RADIUS packet transmission attempts.
•
The RADIUS server response timeout period.
•
The number of RADIUS servers in the RADIUS scheme.
When the device sends a RADIUS request to a new RADIUS server, it checks the total amount of
time it has taken to transmit the RADIUS packet. If the amount of time has reached 300 seconds, the
device stops sending the RADIUS request to the next RADIUS server. As a best practice, consider
the number of RADIUS servers when you configure the maximum number of packet transmission
attempts and the RADIUS server response timeout period.
Examples
# In RADIUS scheme radius1, set the RADIUS server response timeout timer to 5 seconds.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] timer response-timeout 5
Related commands
display radius scheme
retry
113