Mac Filter - HP MSM317 Installation And Configuration Manual

Egress rate
Set the maximum rate at which this port will send traffic. This rate applies to all outgoing traffic
(broadcast, multicast, and unicast). Traffic in excess of the set rate is delayed.
Traffic
Indicates the type of traffic to which egress rate limiting applies. It is set to All (broadcast, multicast,
and unicast), and cannot be changed.

MAC filter

This option lets you control port access based on client station MAC addresses. Addresses are
checked against one or more lists stored on the controller. If the MAC address of a connected
device appears in any selected list, then the device is permitted to send and receive traffic on the
port.
To configure MAC-based filters on an access device switch port, do the following:
1. Open the management tool on the controller.
2. Select Controller >> Authentication > MAC lists.
3. Select Add New MAC List. The Add/Edit MAC list page opens.
Each entry in the MAC list contains a MAC address and its associated mask. By varying the
mask, an entry can be defined to match a single address or a range of addresses.
Configuring the switch ports 25