Arp Resolving-Route Probe-Interval - HP FlexNetwork MSR Series Command Reference Manual

Use undo arp resolving-route probe-count to restore the default.
Syntax
arp resolving-route probe-count count
undo arp resolving-route probe-count
Default
The device performs three ARP blackhole route probes for each unresolved IP address.
Views
System view
Predefined user roles
network-admin
Parameters
count: Sets the number of probes, in the range of 1 to 25.
Examples
# Configure the device to perform three ARP blackhole route probes for each unresolved IP address.
<Sysname> system-view
[Sysname] arp resolving-route probe-count 3
Related commands
arp resolving-route enable

arp resolving-route probe-interval

arp resolving-route probe-interval
Use arp resolving-route probe-interval to set the interval at which the device probes ARP
blackhole routes.
Use undo arp resolving-route probe-interval to restore the default.
Syntax
arp resolving-route probe-interval interval
undo arp resolving-route probe-interval
Default
The device probes ARP blackhole routes every 1 second.
Views
System view
Predefined user roles
network-admin
Parameters
interval: Specifies the probe interval in the range of 1 to 5 seconds.
Examples
# Configure the device to probe ARP blackhole routes every 3 seconds.
<Sysname> system-view
[Sysname] arp resolving-route probe-interval 3
937