Arp Scanning And Fixed Arp Commands - HP FlexNetwork MSR Series Command Reference Manual

Syntax
reset arp detection statistics [ interface interface-type interface-number ]
Views
User view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Clears the ARP attack detection statistics of an interface.
Usage guidelines
If you do not specify an interface, this command clears the statistics of all interfaces.
Examples
# Clear the ARP attack detection statistics of all interfaces.
<Sysname> reset arp detection statistics

ARP scanning and fixed ARP commands

arp fixup
Use arp fixup to convert existing dynamic ARP entries to static ARP entries.
Syntax
arp fixup
Views
System view
Predefined user roles
network-admin
Usage guidelines
The ARP conversion is a one-time operation. You can use this command again to convert the
dynamic ARP entries learned later to static.
The static ARP entries converted from dynamic ARP entries have the same attributes as the
manually configured static ARP entries. Due to the device's limit on the total number of static ARP
entries, some dynamic ARP entries might fail the conversion.
The static ARP entries after conversion can include the following entries:
•
Existing dynamic and static ARP entries before conversion.
•
New dynamic ARP entries learned during the conversion.
Dynamic ARP entries that are aged out during the conversion are not converted to static ARP
entries.
To delete a static ARP entry changed from a dynamic one, use the undo arp ip-address
[ vpn-instance-name ] command. To delete all such static ARP entries, use the reset arp all or reset
arp static command.
Examples
# Enable fixed ARP.
<Sysname> system-view
950