Symmetricom TimeProvider 1000 User Manual page 173

Table 6-7. Alarms (Continued)
Alarm ID
Alarm Condition
Or
Description
CONDTYPE
INPFRQ The specified input
port's calculated
received frequency is
exceeding the pull-in
range of the local
oscillator. The received
signal's calculated
frequency alarmed
condition disqualifies
the input as a possible
reference. After
INPFRQ is set, the
alarm clears when the
input frequency is within
the defined pull-in range
limits.
INPPHASE The specified input port
has a excessive phase
measurement that is
disqualifies it from being
used.
EXDSC Input has had excessive
discontinuities. This is
indicated when there
are more than three
signal faults of the same
type within a five minute
window. The alarm
clears when the five
minute window contains
less than three alarms
of the same type.
FFOFF Input has exceeded the
Fractional Frequency
Offset threshold.
MTIE Input has exceeded at
least one of the MTIE
alarm thresholds.
097-58001-02 Revision C – August 2005
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Error
AID Service
Delay
TYPE Affecting
Default
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
Troubleshooting the TimeProvider
Alarm Default
Error
Level
Delay
Editable
SSU PRS SUB
NO MN MN
NO MN MN
NO MN MN
NO MN MN
NO MN MN
TimeProvider User's Guide 173
NR
MN
MN
MN
MN