Symmetricom TimeProvider 1000 User Manual page 165

Table 6-6. Set and Clear Conditions for Alarms
Alarm ID Set Alarm Conditional Description
IOC1TO2COMM IOC1 to IOC2 communication failed
IOCFAIL IOC hardware failure
BTBCKUP BesTime backup reference disqualified
CLKBRDG Clock is in Bridging mode
CLKFREE Clock entered Free-run mode
CLKHOLD Clock entered Holdover mode
CLKWARM Clock entered Warm-up mode
SYNTHEOR Output generator exceeded pull-in
range
IOC2COMM IOC2 to IMC communication failed
IOC2TO1COMM IOC2 to IOC1 communication failed
IOCFAIL IOC hardware failure
BTBCKUP BesTime backup reference disqualified
CLKBRDG Clock entered Bridging mode
CLKFREE Clock entered Free-run mode
CLKHOLD Clock entered Holdover mode
CLKWARM Clock entered Warm-up mode
SYNTHEOR Output generator exceeded pull-in
range
ANTCOMM GPS antenna communication fault
GPSPOS GPS antenna position unknown
GPSPWR GPS power fault
GPSSYS GPS system fault
GPSTRK GPS is not tracking satellites
INPDISQ GPS input is disqualified
INPLOS LOS fault
INPFRQ Frequency threshold exceeded
INPPHASE Phase error exceeded threshold
097-58001-02 Revision C – August 2005
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Clear Alarm Conditional Description
IOC1 to IOC2 communication established
IOC hardware restored
BesTime backup sources qualified
Clock exited Bridging mode
Clock exited Free-run mode
Clock exited Holdover mode
Clock exited Warm-up mode
Output generator within pull-in range
IOC2 Codes
IOC2 to IMC communication established
IOC2 to IOC1 communication established
IOC hardware restored
BesTime backup sources qualified
Clock exited Bridging mode
Clock exited Free-run mode
Clock exited Holdover mode
Clock exited Warm-up mode
Output generator within pull-in range
GPS Codes
GPS antenna comm fault cleared
GPS antenna position known
GPS power fault cleared
GPS system OK
GPS is tracking satellites
GPS input is enabled
LOS fault cleared
Frequency within threshold
Phase error within threshold
Troubleshooting the TimeProvider
TimeProvider User's Guide 165