Symmetricom TimeProvider 1000 User Manual page 166

Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
Table 6-6. Set and Clear Conditions for Alarms
Alarm ID Set Alarm Conditional Description
EXDSC Excessive discontinuity fault
FFOFF FFOFF exceeded threshold
MTIE MTIE exceeded threshold
TPIUSIG TPIU signal fault
INPDISQ Input disqualified as possible
reference
INPAIS AIS fault
INPLOS LOS fault
INPOOF OOF fault
INPFRQ Frequency threshold exceeded
INPPHASE Phase error exceeded threshold
INPQL Quality Level (SSM) exceeded
threshold
INPTRR Tip/ring reversal on input
EXDSC Excessive discontinuity fault
MTIE MTIE exceeded threshold
OUTFAIL Output fault
SYNTHEOR Output generator exceeds pull-in range
SYNTHFAIL Output generator failed
S1LOS Side 1 LOS fault
S2LOS Side 2 LOS fault
EXSLIP Slip rate threshold exceeded
FRMFAULT Retimer module has a fault
166 TimeProvider User's Guide
PRS and INP[p] Codes
OUT[g] Codes
RTMg[-p] Alarm Conditions
Clear Alarm Conditional Description
Excessive discontinuity cleared
FFOFF within threshold
MTIE within threshold
TPIU signal fault cleared
Input qualified as possible reference
AIS fault cleared
LOS fault cleared
OOF fault cleared
Frequency within threshold
Phase error within threshold
Quality Level (SSM) within threshold
Tip/ring connection correct
Excessive discontinuity cleared
MTIE within threshold
Output fault cleared
Output generator within pull-in range
Output generator restored
Side 1 LOS fault cleared
Side 2 LOS fault cleared
Slip rate within threshold
Retimer module fault has cleared
097-58001-02 Revision C – August 2005