Symmetricom TimeProvider 1000 User Manual page 120

Chapter 4 Provisioning the TimeProvider
Provisioning Alarms
Description of Alarm
Alarm ID
Condition
INPQL The received SSM is of
lesser quality than the
provisioned QLEVEL
for a specified input.
This alarm occurs when
you provision the
input's QLEVEL below
the quality level of the
LO.
EXDSC Input has had excessive
discontinuities, indicated
by more than 3 signal
faults of the same type
within a 5-minute period.
The alarm clears when
the 5-minute window
contains less than 3
alarms of the same type.
S1LOS Side 1 LOS fault
S2LOS Side 2 LOS fault
EXSLIP Input has excessive slip
rate.
RTMFAULT IOC cannot determine if
the Retimer is
functioning properly.
Note:
1
When the fault is detected, the input is immediately removed from the possible reference
list. The fault must be continuously present for the period specified by FLTDELAY before
the alarm is set. After the alarm is set, it clears once the input signal is fault-free for the
period specified by CLRDELAY.
2
When the fault is detected, the input is immediately removed from the possible reference
list. The fault must be continuously present for the period specified by FLTDELAY before
the alarm is set. After the alarm is set, it clears once the input signal is fault-free for the
period specified by CLRDELAY.
3
Once INPFREQ is set, the alarm clears when the input frequency is within the defined
pull-in range
Sample Command
SET-ATTR::SYS:TS1000::ELEVTIME=ENABLE;
120 TimeProvider User's Guide
Possible Error
Alarm Delay
Levels Default
NR | NA | IMMED
MN | MJ |
CR
NR | NA | IMMED
MN | MJ |
CR
<aid> = RTM
MN | MJ | IMMED
CR
MN | MJ | IMMED
CR
NR | NA | IMMED
MN | MJ |
CR
NR | NA | IMMED
MN | MJ |
CR
Default Level
Error
Delay
SSU
Editable?
Mode
No MN
No MN
No MN
No NA
No NA
Yes NA
097-58001-02 Revision C – August 2005
SUB
Mode
MN
MN
MN
NA
NA
NA