Symmetricom TimeProvider 1000 User Manual page 163

Table 6-5. Event Codes (Continued)
Event ID
Description
LOCTIM The local system time
offset has changed
REFMODE Indicates if the
system reference can
be selected
automatically or by
the user
TIMCHG The system time has
been changed
CKTIDCHG User modified the
Circuit ID for the
output.
FREEFLT Defines the Retimer
mode when the
system is in Free-run
mode.
HOLDFLT Defines the Retimer
mode when the
system is in Holdover
mode.
RTMLBO The specified
Retimer port Line
Build-Out has
changed.
097-58001-02 Revision C – August 2005
Keyword AID
TYPE
EQPT
EQPT
EQPT
RTM Events
T1
T1
T1
T1
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
Default Value/
Description of Values
Keyword
(00)-00
(hh) – hours offset
mm – minutes offset 00 to
59
AUTO AUTO – System uses
QLEVEL and Priority to
select the system reference
FORCED – User selects
the system reference. If the
selected reference fails,
this value reverts to AUTO
mode
hh-mm-ss hh – hours (24-hour clock)
mm – minutes
ss – seconds
RTMg[-p] The Circuit ID can be up to
40 characters in length
SQUELCH RETIME – In fault mode,
retime signals on Retimer
module
CUTTHRU – In fault mode,
Retimer module is in
cutthrough mode and
signals are not retimed
SQUELCH RETIME – In fault mode,
retime signals on Retimer
module
CUTTHRU – In fault mode,
Retimer module is in
cutthrough mode and
signals are not retimed
0 0 = 0 to 133 ft
1 = 133 to 266 ft
2 = 266 to 399 ft
3 = 399 to 533 ft
4 = 533 to 650 ft
TimeProvider User's Guide 163
±
12