Testing The Outputs; Test Record; Record Of Test Results - Symmetricom TimeProvider 1000 User Manual

Testing the Outputs

The TimeProvider supports up to 32 output signals on four output groups. You can
provision the output signal to the following types: 2M, CAS, D4, ESF, CC, JCC,
JCC4, 1.544 MHz, 6.312 MHz, 8 kHz, or ISOLATED_1.
To test the outputs, connect the communications analyzer to the output under test
and observe that the waveforms meet or exceed the specifications for that signal
type.

Test Record

Use Table 5-3
Table 5-3. Record of Test Results
Test
Verifying Normal Operation
IOC Operating Modes
Reference Switching
Non-Revertive Mode
Revertive Mode
Power Alarms
Input Errors
Local Serial Port
Remote Serial Port
Ethernet Port
Outputs
097-58001-02 Revision C – August 2005
to record the results of the tests performed on the TimeProvider.
Results (Pass/Fail)
Chapter 5 Testing the TimeProvider
Testing the Outputs
Date Initials
TimeProvider User's Guide 143