Symmetricom TimeProvider 1000 User Manual page 162

Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
Table 6-5. Event Codes (Continued)
Event ID
Description
CLRDELAY Time, in seconds,
before a faulted
signal indicates it is
valid as a system
reference
ELEVTIME Indicates that Alarm
elevation time (1440
min.) is enabled or
disabled
FACTORY Indicates that the unit
has been reset to
Factory default. All
modules installed in
the system are reset
FLTDELAY Time, in seconds,
before faulted signal
indicates it is not
valid as a system
reference
FREEFLT Indicates if the
Output Fault is issued
when the local
oscillator enters
Free-Run mode.
HOLDFLT Indicates if the
Output Fault is issued
when the local
oscillator enters
Holdover mode
INPREF Indicates if the
system automatically
selects another
reference input.
Operator has
enabled the selected
reference input
(REFMODE must be
set to FORCED)
162 TimeProvider User's Guide
Keyword AID
TYPE
SYS Events
EQPT
EQPT
EQPT
EQPT
EQPT
EQPT
T1
Default Value/
Description of Values
Keyword
5 s 0 to 1000 s
DISABLE ENABLE | DISABLE
n/a n/a
10 s 1 to 15 s
SQUELCH ON – In fault mode,
generate outputs based on
system SSM
AIS – In fault mode,
generate AIS outputs
SQUELCH – In fault mode,
outputs are turned off
ON ON – In fault mode,
generate outputs based on
system SSM
AIS – In fault mode,
generate AIS outputs
SQUELCH – In fault mode,
outputs are turned off
PRS PRS – PRS input is
selected as reference
INP1 – INP1 is selected as
reference
INP2 – INP2 is selected as
reference
097-58001-02 Revision C – August 2005