Symmetricom TimeProvider 1000 User Manual page 171

Table 6-7. Alarms (Continued)
Alarm ID
Alarm Condition
Or
Description
CONDTYPE
INPDISQ The specified input was
Disqualified or Qualified
as a possible system
reference. The fault
condition must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPDISQ is set the
alarm clears when the
input signal is fault free
for the Clear Delay Time
(CLRDELAY).
INPLOS The 1PPS from GPS is
LOS. The LOS must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPLOS is set, the
alarm clears when the
input signal is LOS free
for the Clear Delay Time
(CLRDELAY).
INPPHASE The specified input port
has a excessive phase
measurement that is
disqualifies it from being
used.
EXDSC Input has had excessive
discontinuities. This is
indicated when there are
more than 3 signal faults
of the same type within a
5 minute window. The
alarm clears when the 5-
minute window contains
less than 3 alarms of the
same type.
FFOFF Input has exceeded the
Fractional Frequency
Offset threshold.
097-58001-02 Revision C – August 2005
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Error
AID Service
Delay
TYPE Affecting
Default
T1 NSA FLT
DELAY
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
Troubleshooting the TimeProvider
Alarm Default
Error
Level
Delay
Editable
SSU PRS SUB
YES MN MN
NO MN MN
NO MN MN
NO MN MN
NO MN MN
TimeProvider User's Guide 171
MN
MN
MN
MN
MN