Table of Contents
Advertisement
Adjusting feed dog and needle bar linkage
7.4 Aligning the needle bar linkage in the sewing direction
Fig. 35: Aligning the needle bar linkage in the sewing direction
(1) - Screw
Proper setting
If the stitch length is 0, the needle pierces exactly in the center of the
needle hole.
To align the needle bar linkage in the sewing direction:
1. Switch off the machine.
2. Disassemble the front cover ( p. 20).
3. Switch on the machine.
4. Execute the service routine Needle-Hook > Needle bar ( p. 14).
The software is used to define the necessary presettings on
5. Loosen the screw (1).
6. Move the needle bar linkage until there is a distance of 10 mm between
7. Tighten the screw (1).
8. Finish the service routine.
9. Assemble the front cover.
Service Instructions D867 e-con - 00.0 - 08/2023
10 mm
the machine.
presser bar and walking foot bar.
①
49
Advertisement
Table of Contents
