Mounting The Secondary Remotes; Mounting The Dlx-Acu200 - Invacare LiNX Service Manual

1. Connect slip sticker A with joint arm B and insert into
support C.
2. Fix with sleeve nut D, washer E and screw F.
Apply medium-strength thread-locking fluid to
screw F.
3. Insert locking bolt H and compression spring I through
support C and joint arm B.
4. Fix with locking knob G and grub screw J .
Apply medium-strength thread-locking fluid to
grub screw J.
5.
Insert bracket O into joint arm B, clamp ball N and
clamp ring M.
Fix with screws L.
6. Mount remote T to support plate S and clamping bush
R with washers Q and screws P.
Nucleus remote holder
• 4 mm Allen key
• 3/16" Allen key
1. Mount remote C to bracket B with screws A.
2. Pull bracket B over nucleus E.
3. Tighten bracket to nucleus with screw D.
1605129-C

3.10 Mounting the secondary remotes

For more information about how remote holders
are mounted to the wheelchair, refer to the service
manual of the seating system.

3.10.1 Mounting the DLX-ACU200

Mounting for Modulite seating system
• 3 mm Allen key
• 5 mm Allen key
• 8 mm wrench
• 10 mm wrench
1.
Attach gripper clamp A to tube with screws B and nuts
C.
2.
Attach clamp A and spacers B to gripper clamp with
screws C.
3.
Risk of damage to the remote
The maximum torque to tighten the screw
is 1 Nm.
– Do not exceed this rating as it may damage
the remote.
Assembly
31