File Context Actions; Open/Close A File; Remove A File From List; Writing Bundle Files To A Chair - Invacare LiNX Service Manual

Invacare® LiNX
The default chair configuration means the last
connected configuration.
If chair configurations are not supported, such as
in LiNX LE systems, Reset to Default button is not
displayed.

8.6 File context actions

The following tasks are only relevant when in the File
context mode. For tasks related to the Connection context
mode, refer to 8.5 Connection context actions, page 74.

8.6.1 Open/Close a file

If the LiNX Access PC tool is not open
1. Open LiNX Access PC tool.
2. From Open a file tab:
a. select file from list, or
b. click Open file button (top left) to open the Open
file dialogue, or
c. if list is too long to read, enter file name into Filter
files text box to locate file in list.
3. Select file.
If the LiNX Access PC tool is already open
1. Click on New file tab (+).
2. From this tab:
a. select file from list, or
b. click Open file button (top left) to open the Open
file dialogue, or
c. enter file name into Filter files text box to locate file
in list.
3. Select file.
Open via File menu
1. Click on File menu.
2. Select Open file to open the Open file dialogue.
3. Select file.
After selecting a file, the LiNX Access PC tool opens the file
under its own tab. The tab is named with the file name.
Close a file
Close a file using the Close file button, located on the
right-hand side of the tool bar. If you attempt to close a file
with changes pending, a dialogue opens with the options to:
• Save — save the changes before closing
• Discard — discard the changes and close the file
• Cancel — cancel the file close action
For information about modifying parameters, refer to 9
Modifying wheelchair configuration with PC tool, page 77.
For information about saving files, refer to 8.5.4 Save a
program as a file, page 75. For information about reading a
program, refer to 8.5.3 Read a program from a wheelchair,
76
page 74 and for information about writing a program to a
wheelchair, refer to 8.5.2 Write a program to a wheelchair,
page 74.

8.6.2 Remove a file from list

Right-click on a file in the open file dialogue and select
Remove from list.

8.6.3 Writing bundle files to a chair

Bundle files can be written to a connected chair. Bundle files
can include wheelchair configurations and/or firmware files.
1.
Click on File menu.
Select Write Bundle File.
2.
Select desired bundle file and click Open.
3.
Bundle file is written to chair.
1605129-C