Mounting The 10 Way Switch For Ultra Low; Maxx - Invacare LiNX Service Manual

The 10 way switch is fitted to the rear of the wheelchair
using a bracket B on the push handle or push bar.
1. Tighten mounting plate D with screws C to 10 way
switch E.
2. Pull screws A through bracket B and mounting plate D.
In combination with DLX-REM050 (attendant control unit)
1. Tighten 10 way switch to mounting plate D with screws
C.
2. Tighten mounting plate D to mounting plate B with
screws A.
1605129-C
For the possible positions of the attendant control
unit, refer to 3.9.3 Mounting the DLX-REM400, page
29.
3.12.2 Mounting the 10 way switch for Ultra Low Maxx
Mounting at the front
In combination with DLX-REM2XX or DLX-REM400
• 3 mm Allen key
• 8 mm wrench
1.
Mount joystick holder A to remote adapter B with
screws C, washers D and nuts E.
2.
DLX-REM2XX
Mount remote L to remote adapter B and support
sheet J with screws F and washers G.
3. Mount 10 way switch K to support sheet J with screws
H and washers I.
For more information about mounting the 10 way switch for
attendants, refer to the service manual of the Ultra Low

Maxx.

Assembly
DLX-REM400
39