Mounting The Eclipse Tray With Proximity; Sensors; Mounting The 10 Way Switch; Mounting The 10 Way Switch For Modulite - Invacare LiNX Service Manual

Invacare® LiNX
3.11.4 Mounting the eclipse tray with proximity sensors
• 3/32" Allen key
• 5/32" Allen key
• 3/16" Allen key
• 4x loop straps 25x100 mm
• 4x hook straps 25x100 mm
1.
Fix hook straps B inside eclipse tray A.
2. Cut loop straps C accordingly shape of proximity sensors
D.
3. Fix loop straps to proximity sensors.
4. Fix loop straps to hook straps.
5.
Pay attention that wiring of proximity sensors
fit into intended gaps.
Fix coverage E to eclipse tray with screws F.
6.
Insert clamp plate G into cutout on eclipse tray.
7. Fix clamp plate, clamp ball H and upper clamp plate I
with screws J.
8. Screw hitch mount K to clamp ball with grub screw L.
9.
Pull hitch mount over nucleus M and tighten with screw
N.

3.12 Mounting the 10 way switch

For more information about how 10 way switch
holders are mounted to the wheelchair, refer to the
service manual of the seating system.
While mounting the 10 way switch or changing the labeling,
the orientation spot A must face downwards, see table
below.
38
Orientation right

3.12.1 Mounting the 10 way switch for Modulite

Mounting at the front
• 3 mm Allen key
• 4 mm Allen key
• 8 mm wrench
1. Tighten 10 way switch to bracket with screws C and
washers B.
2. Tighten bracket to remote mounting tube F with screws
A, washers D and nuts E.
3. Insert remote mounting tube inside mounting bracket G.
4. Adjust 10 way switch to desired position.
5. Tighten wing screw H.
In combination with DLX-REM211/DLX-REM216
1. Tighten 10 way switch to bracket D with screws B and
washers C.
2. Tighten bracket to remote mounting bracket with screws
A.
Mounting at the rear (for attendants)
• 3 mm Allen key
• 4 mm Allen key
Orientation wrong
1605129-C