Compax3 Device Description; Meaning Of The Status Leds - Compax3 Axis Controller; Meaning Of The Status Leds - Compax3Mp (Mains Module) - Parker Compax3S025V2 Operating Instructions Manual

Compax3 device description

3. Compax3 device description
3.1

Meaning of the status LEDs - Compax3 axis controller

Note on Compax3H:
3.2 Meaning of the status LEDs - Compax3MP (mains
module)
22
In this chapter you can read about:
Meaning of the status LEDs - Compax3 axis controller.....................................................................22
Meaning of the status LEDs - Compax3MP (mains module).............................................................22
Connections of Compax3S ................................................................................................................23
Compax3MP/Compax3M connections ..............................................................................................34
Connections of Compax3H................................................................................................................43
Communication interfaces .................................................................................................................53
Signal interfaces ................................................................................................................................56
Installation and dimensions Compax3 ...............................................................................................60
Safety function - safe standstill - Compax3S ...................................................................................68
Device status LEDs
Voltages missing
During the booting sequence
- No configuration present.
©
- SinCos feedback not detected.
- Compax3 IEC61131-3 program not compatible with
Compax3 Firmware.
- no Compax3 IEC61131-3 program
- For F12: Hall signals invalid.
Axis without current excitation
Power supplied to axis; commutation calibration
running
Axis with current excitation
Axis in fault status / fault present / axis energized
(error reaction 1)
Axis in fault status / fault present / axis deenergized
(error reaction 2)
Compax3 faulty: Please contact us.
The internal device status LEDs are only connected to the external housing LEDs,
if the RS232 jumper at X10 is fitted to the control and the upper dummy cover is
fitted.
C3MP10 Status LEDs
Control voltage 24 VDC iss missing
Error of mains module*
DC power voltage is built up
Phase failure / mains power supply undervoltage
Address assignment CPU active
Address assignment CPU completed
C3MPxx Ready - State
*can be read out in each axis controller
192-120101 N11 C3I11T11 November 2007
Positioning via digital I/Os
Right LED (red) Left LED (green)
off off
alternately flashing
Flashes slowly off
off Flashes slowly
off Flashes quickly
off on
Flashes quickly on
on off
on on
Left LED (green) Right LED (red)
off off
off on
- Flashes quickly
on Flashes slowly
Flashes quickly -
Flashes slowly -
on off