Offset Alignment; Gain Alignment - Parker Compax3S025V2 Operating Instructions Manual

Parker EME
4.4.8.1
4.4.8.2
or
by directly entering under optimization: Analog Input

Offset alignment

Performing an offset alignment when working with the ±10V analog interface in the
optimization window under optimization: Analog input Offset [170.4].
Enter the offset value for 0V input voltage.
The currently entered value is shown in the status value "analog input" (optimizing
window at the top right) (unit: 1 ≡ 10V). Enter this value directly with the same sign
as offset value.
The status value "analogue input" shows the corrected value.

Gain alignment

Performing an offset alignment when working with the ±10V analog interface in the
optimization window under optimization: Analog Input: Gain [170.4].
A gain factor of 1 has been entered as default value.
The currently entered value is shown in the status value "analogue input"
(optimising window at the top right).
The status value "analogue input" shows the corrected value.
192-120101 N11 C3I11T11 November 2007
Setting up Compax3
193