Packaging, Transport, Storage - Parker Compax3S025V2 Operating Instructions Manual

Parker EME
1.3

Packaging, transport, storage

Packaging material and transport
Caution! The packaging material is inflammable, if it is disposed of improperly by burning,
lethal fumes may develop.
First device checkup
Storage
Disposal
The packaging material must be kept and reused in the case of a return shipment.
Improper or faulty packaging may lead to transport damages.
Make sure to transport the drive always in a safe manner and with the aid of
suitable lifting equipment (Weight (see page 305, see page 295)). Do never use
the electric connections for lifting. Before the transport, a clean, level surface
should be prepared to place the device on. The electric connections may not be
damaged when placing the device.
Check the device for signs of transport damages.
Verify, if the indications on the Type identification plate (see page 10)
correspond to your requirements.
Check if the consingment is complete.
If you do not wish to mount and install the device immediately, make sure to store it
in a dry and clean environment (see page 306). Make sure that the device is not
stored near strong heat sources and that no metal chippings can get into the
device.
This product contains materials that fall under the special disposal regulation from
1996, which corresponds to the EC directory 91/689/EEC for dangerous disposal
material. We recommend to dispose of the respective materials in accordance with
the respectively valid environmental laws. The following table states the materials
suitable for recycling and the materials which have to be disposed of separately.
Material
Metal
Plastic materials
Circuit boards
Please dispose of the circuit boards according to one of the following methods:
Burning at high temperatures (at least 1200°C) in an incineration plant licensed
in accordance part A or B of the environmental protection act.
Disposal via a technical waste dump which is allowed to take on electrolytic
aluminium condensers. Do under no circumstances dump the circuit boards at a
place near a normal waste dump.
192-120101 N11 C3I11T11 November 2007
suitable for Disposal
recycling
yes
yes
no yes
Introduction
no
no
11