Test Commissioning Of A Compax3 Axis; Selection Of The Supply Voltage Used; Motor Selection; In This Chapter You Can Read About: Test Commissioning Of A Compax3 Axis - Parker Compax3S025V2 Operating Instructions Manual

Parker EME
Configuration
4.1.1.

Test commissioning of a Compax3 axis

4.1.2.

Selection of the supply voltage used

4.1.3.

Motor Selection

Then you can double click on "Configuration" to start the configuration wizard. The
wizard will lead you through all input windows of the configuration.
Input quantities will be described in the following chapters, in the same order in which you are queried about them by the configuration
wizard.
In the device online help, we show you at this place an animation of a test
setup with the aim to move an unloaded motor.
Simple and independent of the Compax3 device variant*
Without overhead for configuration
Without special knowledge in programming
* for device specific functions, please refer to the corresponding device description.
Due to continuous optimization, individual monitor displays may have changed.
This does however hardly influence the general proceeding.
Please select the mains voltage for the operation of Compax3.
This influences the choice of motors available.
The selection of motors can be broken down into:
Motors that were purchased in Europe and
Motors that were purchased in the USA.
You will find non-standard motors under "Additional motors" and
Under "User-defined motors" you can select motors set up with the C3
MotorManager.
For motors with holding brake SMHA or MHA brake delay times can be entered.
For this see also Brake delay times (see page 231).
Please note the following equivalence that applies regarding terms to linear
Rotary motors / linear motors
Rotations ≡ Pitch
rotational speed ≡ speed
torque ≡ force
moment of inertia ≡ load
Notes on direct drives (see page 251) (Linear and Torque – Motors)
192-120101 N11 C3I11T11 November 2007
motors:
Setting up Compax3
77