Removing The Media Cage - Lenovo HX1310 Installation And Service Manual

Step 10. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices
and the server.
Step 11. Start the Setup Utility and reset the configuration.
• Set the system date and time.
• Set the power-on password.
• Reconfigure the server.
See "Using the Setup Utility" on page 31 for details.

Removing the media cage

Use this information to remove the media cage.
To remove the media cage (also known as the front I/O cage), complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the
cover (see "Removing the cover" on page 104).
Step 3. Remove the air baffle (see "Removing the air baffle" on page 106).
Step 4. Disconnect the cables that may be attached to the system board. This may include the front USB
connector assembly, front video connector assembly, operator information panel assembly, or
LCD operating panel assembly cables. After disconnecting the cables, slightly lift the release latch;
then, carefully push the media cage out of the chassis and set it aside.
Note: Remember the cable routing before disconnecting the cables from the system board.
142
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide