Operator Information Panel; Lcd Operating Panel Assembly - Lenovo HX1310 Installation And Service Manual

• Operator information panel: Use this information for an overview of the connectors, LEDs, and buttons
on the server front operator panel.
• LCD system information display panel: Use this information for an overview of the LCD system
information display panel, which displays various types of information about the server.
• Video connector: Connect a monitor to this connector. The video connectors on the front and rear of
the server can be used simultaneously.
Note: The maximum video resolution is 1600 x 1200 at 75 Hz.
• USB connectors: Connect a USB device, such as a USB mouse or keyboard to any of these connectors.

Operator information panel

The following illustration shows the controls and LEDs on the operator information panel.
Locator button/
locator LED
Figure 7. Operator information panel
• Power-control button and power-on LED: Press this button to turn the server on and off manually.
The states of the power-on LED are as follows:
Off: Power is not present or the power supply, or the LED itself has failed.
Flashing rapidly (four times per second): The server is turned off and is not ready to be turned on.
The power-control button is disabled. This will last approximately 20 seconds.
Flashing slowly (once per second): The server is turned off and is ready to be turned on. You can
press the power-control button to turn on the server.
Lit: The server is turned on.
• System-locator button/LED: Use this blue LED to visually locate the server among other servers. A
system-locator LED is also on the rear of the server. This LED is used as a presence detection button as
well. You can use Systems Director or IMM Web interface to light this LED remotely. This LED is controlled
by the IMM. The locator button is pressed to visually locate the server among the others servers.
• Check log LED: When this yellow LED is lit, it indicates that a system error has occurred. Check the
event log for additional information. See "Event logs" on page 57 for more information about event logs.
• System-error LED: When this yellow LED is lit, it indicates that a system error has occurred. A
system-error LED is also on the rear of the server. An LED on the operator information panel or on the
system board is also lit to help isolate the error. This LED is controlled by the IMM.

LCD operating panel assembly

Use this information for an overview of the LCD operating panel assembly, which displays various types of
information about the server.
System-error
LED
.
Chapter 1 The Lenovo Converged HX Series server
15