Table of Contents
Advertisement
a.
Select the empty installation tool and ensure that the handle is in the open position. If the
installation tool handle is not in the open position, use the following instructions for your
installation tool:
• When using the installation tool,
the microprocessor installation tool handle counterclockwise to the open position, and
then release the interlock latch. The following illustration of the installation tool shows the
location of the interlock latch and counterclockwise rotation of the handle before loading
the microprocessor.
Figure 86. Installation tool handle adjustment
b.
Align the installation tool with the screws, as shown in the following graphic, and lower the
installation tool on the microprocessor. The installation tool rests flush on the socket only
when it is aligned correctly.
Figure 87. Installation tool alignment
c.
Using the following instructions for your installation tool to remove the microprocessor.
1
lift the interlock latch and hold it up while you
Installation tool
Microprocessor
Chapter 5
Alignment
pins
.
Removing and replacing components
2
twist
159
Advertisement
Table of Contents
Troubleshooting
