Removing The Rear Hard Disk Drive Cage - Lenovo NeXtScale nx360 M5 Installation And Service Manual

Figure 47. Installation of the front handle
Step 1. Orient the front handle so that the blue release latch is toward the middle of the compute node.
Step 2. Align the hole in the handle with the hole on the compute node where the handle is installed.
Step 3. Using a Phillips screwdriver, install the Phillips #2 screw that secures the handle. Install the screw
that you removed when you removed the handle.
After you install the front handle, install the compute node into the chassis (see "Installing a compute
node in a chassis" on page 105 for instructions).

Removing the rear hard disk drive cage

Use this information to remove the rear hard disk drive cage.
Before you remove the rear hard disk drive cage, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 101.
2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see "Removing a compute
node from a chassis" on page 104 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To remove the rear hard disk drive cage, complete the following steps.
130
Lenovo NeXtScale nx360 M5 Installation and Service Guide