Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2.
Turn off the server and peripheral devices and disconnect all power cords.
Step 3.
Remove the server cover (see "Removing the cover" on page 104).
Step 4.
Disconnect the cables that connect to the SATADOM.
Step 5.
Press the release latch and then remove the SATADOM bracket in the direction as shown.
Figure 110. SATADOM bracket removal
Step 6.
Remove the SATADOM from the holder.
Figure 111. SATADOM removal
Step 7.
If you are instructed to return the SATADOM, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
For service technician only: replacing the SATADOM
Use this information to replace the SATADOM.
To install the SATADOM, complete the following steps:
176
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide
Release latch