Table of Contents
Advertisement
Step 4.
The following illustrations show the cable routing and connectors for the 2.5-inch hot-swap
backplane.
SAS/SATA
configuration
connector
SAS/SATA power
connector
SAS/SATA configuration
and power cable
Figure 60. Eight 2.5-inch hot-swap backplane cable connection
Step 5.
Reinstall the hard disk drives and filler panels (see "Replacing hot-swap hard disk drives" on
page 111).
Step 6.
Reinstall the cover (see "Replacing the cover" on page 105).
Step 7.
Slide the server into the rack.
Step 8.
Reconnect the power cords and any cables that you removed.
Step 9.
Turn on the peripheral devices and the server.
Removing the coin-cell battery
Use this information to remove the coin-cell battery.
The following notes describe information that you must consider when replacing the coin-cell battery.
• Lenovo has designed this product with your safety in mind. The lithium battery must be handled correctly
to avoid possible danger. If you replace the coin-cell battery, you must adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
.
Chapter 5
Removing and replacing components
SAS/SATA signal
cable
137
Advertisement
Table of Contents
Troubleshooting
