Step 4.
Remove the front USB connector assembly from the media cage.
Figure 67. Front USB connector assembly removal for eight 2.5-inch hot-swap hard disk drive server
configuration
Step 5.
If you are instructed to return the front USB connector assembly, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Replacing the front USB connector assembly
Use this information to replace the front USB connector assembly.
To install the front USB connector assembly, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2.
Insert the front USB connector assembly into the media cage.
Front USB assembly
Chapter 5
.
Removing and replacing components
145