Lenovo HX1310 Installation And Service Manual page 142

Step 4. Follow the cabling instructions, if any come with the adapter. Route the adapter cables before
you install the adapter.
Step 5. Insert the adapter into the PCI riser-card assembly, aligning the edge connector on the adapter
with the connector on the PCI riser-card assembly. Press the edge of the connector firmly into
the PCI riser-card assembly. Make sure that the adapter snaps into the PCI riser-card assembly
securely. The following illustrates show the different types of PCI riser-card assemblies:
Figure 51. Adapter installation into a PCI riser-card assembly that has one low-profile slot (for PCI riser-card
assembly connector 1 on system board)
Figure 52. Adapter installation into a PCI riser-card assembly that has one low-profile slot and one full-height
half-length slot (for PCI riser-card assembly connector 2 on system board)
Attention: When you install an adapter, make sure that the adapter is correctly seated in the
riser-card assembly and that the riser-card assembly is securely seated in the riser-card connector
on the system board before you turn on the server. An incorrectly seated adapter might cause
damage to the system board, the riser-card assembly, or the adapter.
Step 6. Install the PCI riser-card assembly in the server (see "Replacing a PCI riser-card assembly" on
page 121).
Step 7. Connect the cable to the newly-installed adapter.
Step 8. Perform any configuration tasks that are required for the adapter.
Step 9. Reinstall the cover (see "Replacing the cover" on page 105).
Step 10. Slide the server into the rack.
Step 11. Reconnect the power cords and any cables that you removed.
Step 12. Turn on the peripheral devices and the server.
128
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide
Adapter
Adapter
Expansion
filler
Expansion
filler
Adapter
Expansion
filler