Table of Contents
Advertisement
Front USB assembly
connector
Figure 66. Media cage installation
Step 3.
Reinstall the air baffle (see "Replacing the air baffle" on page 107).
Step 4.
Reinstall the cover (see "Replacing the cover" on page 105).
Step 5.
Slide the server into the rack.
Step 6.
Reconnect the power cords and any cables that you removed.
Step 7.
Turn on the peripheral devices and the server.
Removing the front USB connector assembly
Use this information to remove the front USB connector assembly.
To remove the front USB connector assembly, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2.
Turn off the server and peripheral devices and disconnect all power cords; then, remove the
cover (see "Removing the cover" on page 104).
Step 3.
Remove the media cage (see "Removing the media cage" on page 142).
144
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide
Operator information
panel connector
Optical drive
connector
LCD display
cable connector
Advertisement
Table of Contents
Troubleshooting
