Step 4.
Remove the screws from the EIA bracket.
Note: Use the T8 torx wedge to remove the screws.
Figure 34. Screw removal
Step 5.
Slightly side the EIA bracket to the right; then, remove it from the chassis.
Figure 35. EIA bracket removal
Replacing the EIA bracket
Use this information to replace the EIA bracket.
To replace the EIA bracket, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
EIA bracket
.
Chapter 5
Removing and replacing components
109