Table of Contents
Advertisement
Step 5.
Loosen the screws. Then, remove the COM port bracket connector from the opening of PCIe
riser 2 assembly.
Figure 79. COM port bracket connector insertion into PCIe riser 2 assembly
Note: For some it may be easier to remove the COM port bracket by first slightly removing PCIe
riser 2 assembly from the system board.
Step 6.
If you are instructed to return the COM port bracket, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Replacing the COM port bracket
Use this information to replace the COM port bracket.
To install the COM port bracket, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables.
Step 3.
If necessary, remove PCIe riser 2 assembly from the system board (see "Removing a PCI riser-card
assembly" on page 120).
154
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
