Table of Contents
Advertisement
COPIER (B188)
Initializing the Developer
1. Turn on the main switch.
2. Load some roll paper in the machine.
NOTE: For loading instructions, see the decals on the top edge of the roll
feeder front cover.
3. Wait for the machine to warm up.
4. Enter SP mode.
• Press the [Clear Modes] key (
• Enter 107.
• Hold down [Clear/Stop] (#) for more than 3 seconds.
• Touch "Copy SP".
5. Enter 2801 001 and press [#].
6. Use the 10-key pad to enter the Lot No. embossed on the top seal of the
developer package, then push [#].
7. When the message prompts you to proceed, touch "Yes".
8. Push [Execute]. Wait for about 2 min.
9. When the message tells you that the operation is finished, touch "Exit".
10. Touch "SP Direct", then use the 10-key pad to enter 2923 001 and push [#].
11. Push [Execute]. The machine enters the drum set mode and dusts the drum
with toner.
12. When the message prompts you that the operation is finished, touch "Exit".
"
).
1-16
28 April 2005
Advertisement
Table of Contents
Troubleshooting
