Ricoh Aficio 480W Dolphin-C2 Service Manual page 249

SP (SERVICE PROGRAM) MODE TABLES
008 RCG
Connect
Timeout
009 RCG Write
to Timeout
010 RCG Read
Timeout
011 Port 80
Enable
5821 Remote Service Address Japan Only
001 CSS PI
Device Code
002 RCG IP
Address
5824 NVRAM Data Upload
Uploads the NVRAM data to an SD card. Push Execute.
Note: When uploading in this SP mode data, the front door must be open.
5825 NVRAM Data Download
Downloads data from an SD card to the NVRAM in the machine. After
downloading is completed, remove the card and turn the machine power off and
on.
Note: The pages-printed data stored by SP8381 to SP8387 are not downloaded.
Sets the length of time (seconds) for the time-out when the
RCG (Remote Communication Gate) connects during a call
via the NRS network.
[1~90/1 sec.]
Sets the length of time (seconds) for the time-out when sent
data is written to the RCG during a call over the NRS
network.
[0~100/1 sec.]
Sets the length of time (seconds) for the timeout when sent
data is written from the RCG during a call over the NRS
network.
[0~100/1 sec.]
Controls if permission is given to get access to the SOAP
method over Port 80 on the NRS network.
[0~1/1]
0: No. Access denied
1: Yes. Access granted.
Sets the PI device code. After you change this setting, you
must turn the machine off and on.
Sets the IP address of the RCG (Remote Communication
Gate) destination for call processing at the remote service
center.
[00000000h~FFFFFFFFh/1]
5-72
28 April 2005