Ricoh Aficio 480W Dolphin-C2 Service Manual page 214

28 April 2005
1103 Fusing Idling
1104 Fusing Temperature
Control
1105 Fusing Temp. Adj.
001 Copy Ready Temperature Sets the copy ready fusing temperature.
003 Low Power Mode
005 Fusing Temperature
Calibration
006 Pressure Temp.
Calibration
1106 Fusing Temperature Display
001 Hot Roller Temperature
002 Pressure Roller
Temperature
1801 Feed Motor Speed Correction DFU
001 Feed Motor: 1st Roll
002 Feed Motor: 2nd Roll
003 Feed Motor: 3rd Roll
004 Feed Motor: 4th Roll
005 Feed Motor: Cut Paper
Tray
006 Registration Motor
007 Fusing Motor
1911 By-pass Feed Start Timing Adj. Adjusts the waiting time for the by-pass paper feed.
SP (SERVICE PROGRAM) MODE TABLES
Selects the fusing idling time.
[0~5/1 min.]
If the fusing temperature is below 100
turned on, idling starts as soon as the hot roller reaches the
target temperature. However, if the fusing temperature is below
o
15 C the hot roller will idle for at least 1 minute, even with this
SP set to "0" (OFF: No idling).
Sets the fusing temperature control.
0: On/Off Control (Pressure Roller Temp. Feedback)
1: Phase Control (Pressure Roller Temp. Feedback)
If the power supply to the machine is unstable, select 1.
[130~160/1°C]
Copying can begin at this temperature, before the hot
roller reaches the control temperature.
Sets the fusing temperature for low power mode.
[90~125/1°C]
Calibrates the scale for the fusing temperature
settings. DFU
[-10~+10/1°C]
Calibrates the scale for the pressure temperature
control. DFU
[-10~+10/1°C]
Displays the hot roller and pressure roller
temperatures.
Adjusts the feed motor speed.
[-15~+15/1% ]
[-50~+50/1]
Adjusts the registration motor speed.
[-20~+20]
Adjusts the fusing motor speed.
[-100~+100/1]
[0.5~8.0/0.1 sec.]
5-37
o
C when the machine is