Using The Sp Mode; Sp Mode Level; Important Points To Remember About Entering Settings For Sp Codes - Ricoh Aficio 480W Dolphin-C2 Service Manual

SERVICE PROGRAM (SP) MODES

5.4.3 USING THE SP MODE

SP mode level

The SP (Service Program) are assigned three-level coded numbers. For example,
SP2101-002 (Printing Erase Margin – Trailing Edge) where:
NOTE: For a detailed listing of all SP codes see, refer to the tables later in this
chapter.
When you open the SP mode, you will see the SP codes listed with the first 4
numbers. Press the appropriate button on the touch panel to access the SP
function.
• An asterisk (*) at the end of a number means that sublevels exist for that SP
code.
• SP codes without the asterisk are accessed immediately and have no sublevels.

Important points to remember about entering settings for SP codes

• In some cases, the screen is not large enough to present all the SP codes at
once. If you do not see the SP code that you want, press the Next and Prev
buttons in the lower right corner of the screen to browse the lists.
• After entering a number for a setting, always press '.
• To toggle between a +/- press the ".
• After you press the button of an SP code that requires a setting, a box opens so
you can enter a number, press a Yes or No button, etc. After entering the
number setting, always press ', and then press Exit to close the entry box.
B188S905.WMF
5-24
28 April 2005