Original Temporary Delay - Ricoh Aficio 480W Dolphin-C2 Service Manual

28 April 2005 SCANNER

6.2.5 ORIGINAL TEMPORARY DELAY

[C]
Inserting the leading edge of the original
[B]
[A] into the feed slot switches on the
[D]
[A]
original set sensor [B], and brings it into
contact with the edge of the original feed
roller [C].
The interval between the time the original
set sensor switches on until the feed roller
starts turning is called Delay 1. It can be
set from 1 to 5 seconds with the "Original
Feed Delay 1" user tool. This delay allows
the user to manually shift the original from
B188D913.WMFF
side to side to correct the alignment of the original.
After Delay 1 expires, the original is fed at 105 mm/s to the registration sensor [D],
where the original pauses again for 1 to 5 seconds. This is called Delay 2 and this
delay allows time for the user to pull the original out if it has fed incorrectly. The
length of Delay 2 can be set with the "Original Feed Delay 2" user tool.
6-9