Genie S-80 Service Manual page 51

February 2017
3 Locate the engine tray anchor hole on the
turntable.
4 Install the bolt that was just removed into the
anchor hole to secure the engine tray from
moving.
Crushing hazard. Failure to
install the fastener into the
engine tray anchor hole to secure
the engine tray from moving
could result in death or serious
injury.
5 Inspect the following areas for burnt, chafed,
corroded pinched and loose wires:
• Engine wiring harness
• Hydraulic manifold wiring
6 Open the ground controls side turntable cover.
7 Inspect the following areas for burnt, chafed,
corroded pinched and loose wires:
• Battery area wiring
• Inside of the ground control box
• Hydraulic manifold wiring
• Hydraulic oil cooler wiring
8 Inspect for a lite, even coating of dielectric
grease in the following locations:
• All wire harness connectors to ground
control box
Note: Do not apply excessive amounts of dielectric
grease to harness connectors, pins or sockets.
Note: Do not apply dielectric grease to a engine
ECU/ECM or engine harness connectors.
Part No. 1259369GT
Checklist B Procedures
9 Start the engine from the ground controls and
raise the boom above the turntable covers.
10 Inspect the turntable area for burnt, chafed
and pinched cables.
11 Lower the boom to the stowed position and
turn the engine off.
12 Inspect the following areas for burnt, chafed,
corroded pinched and loose wires:
• Cable track on the boom
• Cables on the primary, and jib booms
• Jib, rotate, level manifold
• Inside of the platform control box
13 Inspect for a lite, even coating of dielectric
grease in the following locations:
• All wire harness connectors to platform
control box
Note: Do not apply excessive amounts of dielectric
grease to harness connectors, pins or sockets.
14 Remove the engine tray retaining fastener
from the engine tray anchor hole at the pivot
end of the engine tray.
15 Swing the engine tray in towards the machine.
16 Install the engine tray retaining fasteners.
S-80 • S-85 • S-80X
Service Manual
Crushing hazard. Failure to
install the bolt into the engine
pivot plate to secure it from
moving could result in death or
serious injury.
31