How To Install The Flex Plate - Genie S-80 Service Manual

Service Manual
Engines
How to Ins tall the Fl ex Plate

How to Install the Flex Plate

1 Install the flex plate onto the engine flywheel
with the raised spline towards the pump. Apply
Loctite® removable thread sealant to the
mounting screws.
Note: Torque the flex plate mounting bolts in two
stages.
Continental models: Torque the flex plate
mounting bolts in sequence to 20.8 ft-lbs / 28
Nm.
Deutz models: Torque the flex plate mounting
bolts in sequence to 28 ft-lbs / 38 Nm. Then
torque the flex plate mounting bolts in
sequence to 40 ft-lbs / 54 Nm.
Perkins models: Torque the flex plate
mounting bolts in sequence to 28 ft-lbs / 38
Nm. Then torque the flex plate mounting bolts
in sequence to 40 ft-lbs / 54 Nm.
Deutz, Perkins and Continental Flex Plate
110
2 Install the pump coupler onto the pump shaft
with the set screw toward the pump. Leave the
appropriate gap between coupler and pump
end plate for your engine.
3 Apply Loctite® removable thread sealant to
the pump coupler set screw. Torque the set
screw to 61 ft-lbs / 83 Nm.
4 Install the pump onto the pump mounting
plate. Apply Loctite® removable thread
sealant to the pump retaining fasteners.
Torque the pump retaining fasteners to 57
ft-lbs / 77 Nm.
5 Install the pump coupler onto the pump shaft
with the set screw toward the pump. Leave the
appropriate gap between coupler and pump
end plate for your engine.
6 Install the pump and pump mounting plate
assembly onto the engine. Apply Loctite®
removable thread sealant to the mounting
screws.
S-80 • S-85 • S-80X
February 2017
Component damage hazard. Do
not force the drive pump during
installation or the flex plate teeth
may become damaged.
Part No. 1259369GT