February - Genie S-80 Service Manual

February 2017

7 Measuring Tape: Measure the distance
between the center of the pivot pins as shown,
201.75 inches / 512 cm
± 2.0 inch / 5 cm.
Digital Protractor: Place the digital protractor
on the turntable chassis and reset the
protractor to 0°. Place the protractor on top of
the primary boom. The protractor should
display 58° ± 2°.
Result: The primary boom angle is not within
specifications.Consult Genie Product Support.
1 Measure between the centers of these
pivot pins
Part No. 1259369GT
Checklist C Procedures
Platform controls:
Note: Start this procedure with the boom fully
retracted and in the stowed position.
1 Pull out the red Emergency Stop button to the
on position and start the engine.
2 Select the restricted maximum platform
capacity with the toggle switch.
1 restricted maximum platform capacity
2 unrestricted maximum platform capacity
3 Raise the primary boom until it is fully
elevated.
4 Extend the primary boom until it is fully
extended.
5 Lower the primary boom until it stops.
Result: The boom will automatically stop after
10 degrees and the unrestricted platform
capacity light will flash.
Result: The primary boom does not stop after
10 degrees. Calibrate the boom angle sensor.
Refer to Repair Procedure, How to Calibrate
the Boom angle Sensor.
S-80 • S-85 • S-80X
Service Manual
55