Genie S-80 Service Manual page 62

Service Manual
Checklist B Procedures
7 Continue at full speed and note the time when
the machine reference point crosses the finish
line. Refer to Specifications, Performance
Specifications.
Note: To adjust the speed, refer to Repair
Procedure, How to Adjust the Joystick Max-out
Setting.
8 Press down the foot switch and lower the
boom to the stowed position.
9 Extend the boom 3 feet / 90 cm.
10 Choose a point on the machine (i.e., contact
patch of a tire), as a visual reference for use
when crossing the start and finish lines.
11 Bring the machine to top drive speed before
reaching the start line. Begin timing when your
reference point on the machine crosses the
start line.
12 Continue at top speed and note the time when
the machine reference point crosses the finish
line. Refer to Specifications, Performance
Specifications.
Note: To adjust the speed, refer to Repair
Procedure, How to Adjust the Joystick Max-out
Setting.
42
B-18
Test the Alarm and Flashing
Beacon
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
The alarm package includes:
• Travel alarm
• Flashing beacons
Alarms and beacons are installed to alert operators
and ground personnel of machine proximity and
motion. The alarm package is installed on the
turntable rear cover. Beacons are installed on both
turntable covers.
Note: The alarms and beacons will operate with the
engine running or not running.
1 Turn the key switch to ground controls and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls.
Result: Both flashing beacons should be on
and flashing.
2 Move and hold the function enable button to
either side and activate the boom toggle
switch in the down position, hold for a moment
and then release it.
Result: The descent alarm should sound when
the toggle switch is held down.
S-80 • S-85 • S-80X
February 2017
Part No. 1259369GT