How To Bleed The Slave Cylinder; Platform Leveling Slave Cylinder - Genie S-80 Service Manual

February 2017
2-2
Platform Leveling Cylinder
The slave cylinder and the rotator pivot are the two
primary supports for the platform. The slave
cylinder keeps the platform level through the entire
range of boom motion. It operates in a
closed-circuit hydraulic loop with the master
cylinder. The slave cylinder is equipped with
counterbalance valves to prevent movement in the
event of a hydraulic line failure.
How to Remove the Platform
Leveling Cylinder
Note: Before cylinder removal is considered, bleed
the slave cylinder to be sure there is no air in the
closed loop.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
How to R emove the Pl atform Lev eling Slav e C ylinder
1 Extend the primary boom until the slave
cylinder barrel-end pivot pin is accessible.
2 Raise the primary boom slightly and place
blocks under the platform for support.
3 Lower the primary boom until the platform is
resting on the blocks just enough to support
the platform.
Note: Do not rest the entire weight of the boom on
the blocks.
Part No. 1259369GT
4 Remove the pin retaining fastener from the
slave cylinder rod-end pivot pin. Use a soft
metal drift to drive the rod-end pivot pin out.
5 Remove the external snap rings from the
barrel-end pivot pin.
6 Use a soft metal drift to drive the barrel-end
pivot pin out.
7 Carefully pull the cylinder out of the primary
boom to access the hydraulic hoses.
8 Tag, disconnect and plug the hydraulic hoses
from the slave cylinder. Cap the fittings on the
cylinder.
How to Bleed the Sl av e Cylinder

How to Bleed the Slave Cylinder

Note: Do not start the engine. Use auxiliary power
for this procedure.
1 Raise the primary boom to a horizontal
position.
2 Move the platform level toggle switch up and
down through two platform leveling cycles to
remove any air that might be in the system.
S-80 • S-85 • S-80X
Platform Components
Crushing hazard. The jib boom
could fall when the slave cylinder
rod-end pivot pin is removed if
not properly supported.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
Service Manual
85