Genie GS-1530 Service And Repair Manual page 47

September 2016
5 Read and record the IP address.
Note: The display wil only show the
IP address for 3 seconds. Press the
scroll up button to display the IP
address for another 3 seconds.
6 On a PC, laptop or mobile device, set up a
wireless network for the portable router.
Note: Refer to the Operating System's procedure
for connecting to a wireless network.
7 After establishing a new wireless network,
select the appropriate network your portable
wireless router.
Note: Refer to the Operating System's procedure
for connecting to a wireless network.
8 Launch a web browser such as Internet
Explorer ®, Chrome ® or Firefox ® on your
PC, laptop or mobile device. Type the IP
address from step 5 into the web browser
address bar and press enter.
Result: The following screen will be displayed.
Part No. 1272217
9
Note: The username and password are case
sensitive.
10 After using the Smart Link Service Tool web
11 Secure the diagnostic port cover using the
Note: Machines equipped with AGM batteries will
need to select the AGM battery type using the
GCON set parameters screen. Refer to the
Machine Setup procedure in the Service and
Repair manual that is appropriate for your machine.
12 Perform a function test. Refer to the
GS-30 • GS-32 • GS-46 • GS-47
Service and Repair Manual
Ground Controls
Enter the following username and password
then select OK.
Username: smart.link
Password: SL1000
Result: The following screen will be displayed.
site, push in the red Emergency Stop button
and disconnect the CAT5 cable from the
GCON.
retaining fasteners removed in step 3. Do not
over tighten.
Tip over hazard. Updating the
SmartLink software may have
impacted the machines default
drive speeds. Tipping over the
machine will result in death or
serious injury.
Perform drive speed test. Refer
to the Maintenance Manual that
is appropriate for your machine.
Operator's Manual on your machine.
31