Genie GS-1530 Service And Repair Manual page 128

Service and Repair Manual
Scissor Components
42 Use a soft metal drift to remove the number
5 pivot pin (index #18) from the steer end of
the machine. Remove the number 5 inner arm
(index #16) from the machine.
Crushing hazard. The number
5 inner arm (index #16) may
become unbalanced and fall if
not properly supported when
removed from the machine.
43 Tag, disconnect and plug the hydraulic hose
on the upper lift cylinder. Cap the fittings on
the cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
44 Tag and disconnect the wire harness from the
solenoid valve on the cylinder.
45 Remove the cables from the number 4A and
4B cable bridges and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
46 Disconnect the number 4A and 4B cable
bridges from the scissor linkset and remove
both cable bridges from the machine.
47 Attach a lifting strap from an overhead crane
to the lug of the rod end of the upper lift
cylinder.
48 Remove the retaining fasteners from the
upper lift cylinder rod end pivot pin (index #3).
112
49 Use a soft metal drift to remove the upper lift
50 Lower the cylinder onto the linkset.
51 Attach a lifting strap from an overhead crane
52 Remove the retaining fasteners from the
53 Place a rod through the number 4 center pivot
54 Remove the retaining fasteners from the
55 Use a soft metal drift to remove the number
56 Attach a lifting strap from an overhead crane
57 Remove the retaining fasteners from the
GS-30 • GS-32 • GS-46 • GS-47
cylinder rod end pivot pin (index #3) from the
machine.
Crushing hazard. The lift cylinder
will fall if not properly supported
when the pivot pin is removed.
to the number 4 outer arm at the ground
control side (index #20).
number 4 center pivot pin (index #5) at the
ground control side.
pin at the ground control side (index #5) and
twist to remove the pin.
number 4 pivot pin (index #21) at the
non-steer end.
4 pivot pin (index #21) from the non-steer end
of the machine. Remove the number 4 outer
arm at the ground control side (index #20)
from the machine.
Crushing hazard. The number
4 outer arm at the ground control
side (index #20) may become
unbalanced and fall if not
properly supported when
removed from the machine.
to the number 4 outer arm at the battery side
(index #20).
number 4 center pivot pin (index #5) at the
battery side.
September 2016
Part No. 1272217