Genie GS-1530 Service And Repair Manual page 61

September 2016
17 Pull out the red Emergency Stop button to the
on position at the ground controls.
Result: The ground controls LCD display will
show the following:
18 Release the Scroll Up and Scroll Down
buttons after the ground controller powers up.
19 Use the Scroll Up or Scroll Down buttons to
scroll to Select Option.
20 Press the Enter button.
21 Use the Scroll Up or Scroll Down buttons to
scroll to Tilt Sensor.
22 Press the Enter button.
Part No. 1272217
23 Press and hold the Enter button to start
Note: The machine will not calibrate if it is on a
slope of one degree or greater.
Note: If the level sensor has been replaced,
continue with step 24. If the level sensor was not
replaced skip to step 27.
24 Raise the platform 7 to 8 feet / 2.1 to 2.4 m.
25 Return the safety arm to the stowed position.
26 Lower the platform to the stowed position.
27 Place a digital level on the ground control side
28 Drive the steer end of the machine up a ramp
GS-30 • GS-32 • GS-46 • GS-47
Service and Repair Manual
Ground Controls
calibration.
Result: An audible alarm will sound when
calibration is complete.
of the drive chassis. Zero out the digital level.
until it is just under 3°.
45