Genie GS-1530 Service And Repair Manual page 104

Service and Repair Manual
Scissor Components
28 Remove the external snap rings and retaining
fasteners from the number 4 center pivot pins
(index #2).
29 Use a soft metal drift to remove the number
4 center pivot pins (index #2).
30 Remove the retaining fasteners from the
number 4 pivot pin (index #14) at the
non-steer end of the machine.
31 Use a soft metal drift to remove the number
4 pivot pin (index #14) from the non-steer end
of the machine. Remove the number 4 outer
arm (index #13) from the machine.
Crushing hazard. The number
4 outer arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
32 Remove the number 4 cable bridge mounting
fasteners and remove the cable bridge from
the machine.
33 Attach a lifting strap from an overhead crane
to the number 4 inner arm (index #12).
34 Remove the retaining fasteners from the
number 4 pivot pin (index #3).
88
35 Use a soft metal drift to remove the number
36 Remove the cables from the number 3 cable
37 Remove the number 3 cable bridge mounting
38 Attach a lifting strap from an overhead crane
39 Remove the external snap rings and retaining
40 Use a soft metal drift to remove the number
41 Remove the retaining fasteners from the
GS-30 • GS-32 • GS-46 • GS-47
4 pivot pin (index #3) at the steer end.
Remove the number 4 inner arm (index #12)
from the machine.
Crushing hazard. The number
4 inner arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
fasteners and remove the cable bridge from
the machine.
to the number 3 outer arm (index #4) at the
ground controls side.
fasteners from the number 3 center pivot pins
(index #4).
3 center pivot pin (index #4) at the ground
control side.
number 3 pivot pin (index #17) at the
non-steer end of the machine.
September 2016
Part No. 1272217