Genie GS-1530 Service And Repair Manual page 42

Service and Repair Manual
Ground Controls
5 Locate the diagnostic port on the side of the
GCON. Remove one of the fasteners securing
the cover and set aside. Loosen the other
fastener. Do not remove it.
a diagnostic port
6 Connect one end of a CAT5 Ethernet cable
into the diagnostic port. Connect the other end
into a PC or laptop.
Result: The ground controls LCD display will
show the following:
7 Read and record the IP address.
26
8
9
Note: Verify it is the correct flash file.
10 Select the Load Flash File button to verify the
GS-30 • GS-32 • GS-46 • GS-47
Launch a web browser such as Internet
Explorer ®, Chrome ® or Firefox ® on your PC
or laptop. Type the IP address from step 7 into
the web browser address bar and press enter.
Result: The following screen will be displayed.
Select the Choose File button and navigate to
the downloaded Genie Flash file (.gff).
file is a .gff file.
Result: The following screen will be displayed.
September 2016
Part No. 1272217