Genie GS-1530 Service And Repair Manual page 153

September 2016
16 Attach a lifting strap from an overhead crane
or similar lifting device to the barrel end of the
lift cylinder for support.
17 Remove the fasteners from the lift cylinder
barrel-end pivot pin. Use a soft metal drift to
remove the pin.
Crushing hazard. The lift cylinder
will fall if not properly supported
when the pivot pin is removed.
18 Support and secure the lift cylinder to an
appropriate lifting device.
19 Remove the lift cylinder through the scissor
arms at the steer end of the machine.
Crushing hazard. The lift cylinder
will become unbalanced and fall
if not properly supported and
secured to the lifting device.
Component damage hazard. Be
careful not to damage the valve
or fittings on the cylinder while
removing it from the machine.
Part No. 1272217
20 Install new cylinder, fittings, hoses and
Note: At the upper lift cylinder, install the orifice
fitting with the small opening of the orifice fitting
closest to the supply hose.
Torque specifications
Solenoid valve, 2 position 2 way,
N.C.
(schematic item N)
Relief valve
(schematic item Q)
Coil nut
Pressure transducer(if equipped)
(schematic item R)
GS-30 • GS-32 • GS-46 • GS-47
Service and Repair Manual
Scissor Components
pressure transducer (if equipped).
Upper Lift Cylinder
1 lift cylinder
2 orifice(schematic item O)
3 connector fitting
4 hydraulic hose
5 solenoid valve(schematic item N)
6 relief valve(schematic item Q)
20 ft-lbs
27 Nm
20 ft-lbs
27 Nm
5 ft-lbs
7 Nm
27 ft-lbs
37 Nm
137