Genie GS-1530 Service And Repair Manual page 112

Service and Repair Manual
Scissor Components
27 Remove the cables from the number 3 cable
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
28 Disconnect the number 3 cable bridge from
the number 3 outer arm (index #11) and
remove the cable bridge from the machine.
29 Remove the retaining fasteners from the
number 4 pivot pin (index #1).
30 Use a soft metal drift to remove the number
4 pivot pin (index #1). Remove the platform
mount bracket from the machine.
31 Attach a lifting strap from an overhead crane
to the number 3 outer arm at the ground
control side (index #11).
32 Remove the retaining fasteners from the
number 3 center pivot pin (index #2) at the
ground control side.
33 Place a rod through the number 3 center pivot
pin at the ground control side (index #2) and
twist to remove the pin.
34 Remove the retaining fasteners from the
number 3 pivot pin (index #12) at the
non-steer end.
35 Use a soft metal drift to remove the number
3 pivot pin (index #12) from the non-steer end
of the machine. Remove the number 3 outer
arm at the ground control side (index #11)
from the machine.
Crushing hazard. The number
3 outer arm at the ground control
side (index #11) may become
unbalanced and fall if not
properly supported when
removed from the machine.
96
36 Attach a lifting strap from an overhead crane
37 Remove the retaining fasteners from the
38 Place a rod through the number 3 center pivot
39 Remove the number 3 outer arm (index #11)
40 Attach a lifting strap from an overhead crane
41 Remove the retaining fasteners from the lift
42 Use a soft metal drift to remove the lift cylinder
43 Place a 4 x 4 x 10 inch / 10 x 10 x 25 cm block
44 Lower the cylinder onto the block.
45 Attach a lifting strap from an overhead crane
GS-30 • GS-32 • GS-46 • GS-47
to the number 3 outer arm at the battery side
(index #11).
number 3 center pivot pin (index #2) at the
battery side.
pin at the battery side (index #2) and twist to
remove the pin.
from the machine.
Crushing hazard. The number
3 outer arm (index #11) may
become unbalanced and fall if
not properly supported when
removed from the machine.
to the lug of the rod end of the lift cylinder.
cylinder rod end pivot pin (index #3).
rod end pivot pin (index #3) from the machine.
Crushing hazard. The lift cylinder
will fall if not properly supported
when the pivot pin is removed.
onto the number 1 inner arm cylinder plate
(index #8).
Bodily injury hazard. Keep hands
clear of moving parts when
lowering the cylinder.
to the number 3 inner arm (index #10). Raise
the arm to a vertical position.
September 2016
Part No. 1272217